
ICP-VR8488 | Quick Reference Guide | 1.0 Product Contents EN | 6
Bosch Security Systems, Inc. | 12/08 | F01U089640-01
1.0 Product Contents
The Bosch Security Systems, Inc. (Bosch)
ICP-VR8488 Intruder Alarm System includes:
ICP-VR8488 unit (includes case, keypad,
ICP-VR8488 printed circuit board, 433MHz RF
Receiver (RF3213E)
2.0 Introduction
The ICP-VR8488 is a desktop alarm system that
incorporates keyfobs and supervised wireless sensors.
You can assign up to 16 separate wireless devices to
any of the eight available zones.
2.1 Features
• Eight zones
• Eight User Codes
• Eight RF keyfobs
• Supervised battery
• Desktop or wall-mountable
• Up to sixteen supervised wireless sensors
• Telephone line monitor
• Access denied supervision
• Lockout dialer and siren
• AWAY Mode and STAY Mode operations
• Delay reporting
• Day Alarm
• Telephone arming (AWAY Mode)
• Answering machine bypass
• Event memory recall
• Upload and download programmable
• Entry and Exit Warning
• Dual Reporting
• Sensor Watch
• Automatic Arming and Disarming
• AC Fail and Trouble Indicators
• Walk Test Mode
• Automatic Call Forward On and Off
3.0 Installation
1. At the rear of the ICP-VR8488, insert a flat
bladed screwdriver into the slot between the base
and top cover as shown in Figure 1 on page 6.
Figure 1: Opening the Cover
2. Use the screwdriver to pry the top cover up and
forward.
3. Remove the top cover from the base unit as
shown in Figure 2 on page 6. Note that the
keypad and the ICP-VR8488 printed circuit
board (PCB) are connected.
Figure 2: Removing the Cover
1 – Keypad data cable connector
4. Disconnect the data cable at the keypad
connector.
5. Unplug the RF receiver data cable as shown in
Figure 3 on page 7.
Comentarios a estos manuales