Bosch Solution 16plus Especificaciones descargar pdf (Pagina 11)

Arming In STAY Mode 1

STAY Mode 1 is only used when the perimeter and unused areas of the premises need to be

armed to detect any would be intruder from entering the premises and at the same time,

allowing you to move freely within an area that has been automatically isolated. Only your

security company can program zones to be automatically isolated in STAY Mode 1.

There are two different methods for arming the system in STAY Mode 1. Method one is

standard and will always operate. Method two is optional and may be disabled by your

installer if you do not wish to use single button arming.

Entry Guard Timer For STAY Mode

When arming the system in STAY Mode 1, an optional entry timer called Entry Guard

Timer For STAY Mode may be used to delay the sirens if a zone that has not been

automatically isolated has triggered into alarm condition. Entry Guard Timer For STAY

Mode is the delay time used for all zones except 24-hour zones when the system is armed in

STAY Mode 1 or STAY Mode 2.

If the Entry Guard Timer For STAY Mode has been programmed and a zone that has not

been automatically isolated has triggered, the codepad will beep twice a second until the

Entry Guard Timer For STAY Mode has expired or the system has been disarmed. If the

alarm condition has not been reset by entering your user code followed by the # button (eg.

2580#) before the Entry Guard Time For STAY Mode expires, the sirens will activate into

alarm. Only your installer can program this feature.

Method One

How To Arm The System In STAY Mode 1

1. Enter your user code followed by the * button (eg. 2580*).

Two beeps will be heard and the STAY indicator will display. Exit time will now

commence counting.

Any zones that have been programmed to be automatically isolated in STAY Mode 1

will flash until exit time expires. At the end of exit time, all zones selected to be

automatically isolated will extinguish and the codepad will give one short beep.

Method Two

How To Arm The System In STAY Mode 1

1. Press and hold the * button until two beeps are heard.

The STAY indicator will display and exit time will now commence counting.

Any zones that have been programmed to be automatically isolated in STAY Mode 1

will flash until exit time expires. At the end of exit time, the zone indicators will

extinguish and the codepad will give one short beep.

!"#$%&"'()* Operators Manual 11

Electronics Design and Manufacturing Pty Limited ISSUE160.DOC

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Sin comentarios

Bosch Solution 16plus Especificaciones Pagina 11