Bosch Solution 16plus Especificaciones descargar pdf (Pagina 28)

Domestic Voice Message Reporting

The system can be configured by your security company to report to your mobile phone

when an alarm occurs and playback a pre-recorded message detailing instructions.

The pre-recorded message can be changed as many times as necessary (up to a maximum of

16 seconds in length). You will need to discuss the recording of your message with your

security company. To change or program new telephone numbers, refer to Programming

Domestic Telephone Numbers on page 27.

Acknowledging Domestic Voice Message Reporting

When an alarm has registered at the control panel, the control panel will commence dialling

the first telephone number. The recorded voice message will commence playback as soon as

the control panel dials the first telephone number and will repeat itself continuously for 90

seconds.

When you answer the incoming call from the control panel, wait for the recorded message to

end. A series of short tones will follow the recorded message followed by a 20 second pause

before the control panel will hang up and dial the next telephone number.

During the 20 second pause, press the * button on your touch-tone telephone, alternatively,

you may use an optional Phone Controller (tone generator) if you do not have a touch-tone

telephone.

Note

If an optional DTMF Command Module has been installed by your security company,

you can acknowledge the call during the message playback by pressing the # key.

Therefore, you no longer need to wait for the pre-recorded message to end.

!"#$%&"'()* Operators Manual

ISSUE160.DOC Electronics Design and Manufacturing Pty Limited

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Sin comentarios

Bosch Solution 16plus Especificaciones Pagina 28