Bosch Solution 16plus Especificaciones descargar pdf (Pagina 13)

Disarming The System

When you enter the premises after the system has been armed in AWAY Mode, or if you

have armed the system in STAY Mode 1 or STAY Mode 2, you will need to disarm the

system to disable detection devices that will activate an alarm.

If there has been an alarm condition prior to disarming the system, a flashing zone indicator

will be displayed, indicating a previous alarm on that zone.

How To Disarm The System

1. Enter your user code followed by the # button (eg. 2580#).

Two beeps will be heard.

Adding User Codes

Only the Master Code holder can add or change other system user codes including two

Auxiliary Codes and the Master Code itself. The Master Code is factory default as User 1,

however, multiple user codes can be assigned to be a Master Code. Up to 32 user codes may

be programmed to operate the system. User Code 33 and User Code 34 are Auxiliary Codes

only.

How To Add A User Code

1. Enter your Master Code followed by 1 and the # button (eg. 2580 + 1 + #).

Three beeps will be heard and the STAY and AWAY indicators will begin to flash.

2. Enter the user code number (1 – 34) that you wish to add or change followed by the #

button (eg. 2# = User 2 / 33# = Auxiliary Code 1 etc). Two beeps will be heard and

the user number that you just selected will now display on the codepad indicators.

3. Enter the digits required for the new code followed by the # button (eg. If you wish the

user code to be 5768, you would enter 5768# - each user code can be up to 7 digits in

length). Two beeps will be heard and the STAY and AWAY indicators will

extinguish.

If you wish to add or change any further user codes, repeat this procedure as many

times as required.

Deleting User Codes

Only the Master Code holder can delete other system user codes and Auxiliary Code 1 and 2.

How To Add A User Code

1. Enter your Master Code followed by 1 and the # button (eg. 2580 + 1 + #).

Three beeps will be heard and the STAY and AWAY indicators will begin to flash.

2. Enter the user code number (1 – 34) that you wish to delete followed by the # button

(eg. 2# = User 2 / 33# = Auxiliary Code 1 etc). Two beeps will be heard and the user

number that you just selected will now display on the codepad indicators.

3. Press the * button to delete the user code that you have selected.

Two beeps will be heard and the STAY and AWAY indicators will extinguish. If you

wish to delete any further user codes, repeat this procedure as many times as required.

!"#$%&"'()* Operators Manual 13

Electronics Design and Manufacturing Pty Limited ISSUE160.DOC

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Sin comentarios

Bosch Solution 16plus Especificaciones Pagina 13