Bosch Solution 16plus Especificaciones descargar pdf (Pagina 24)

Remote Arming Via Telephone

This feature allows you to arm your system from any remote location via the telephone. For

obvious security reasons, the system cannot be disarmed using this method. To make use of

this feature, you will require a touch-tone telephone and a phone controller. Your security

company needs to program this feature to operate.

How To Remotely Arm Your System Via The Telephone

1. Call the telephone number that your control panel is connected to.

2. When the control panel answers the incoming call, a short jingle will be heard. Hold

the phone controller to the mouthpiece of the telephone and press the side button of

the phone controller for 3 seconds to arm the system.

Alternatively, if your security company has installed an optional DTMF command

module, you can press the # key on a touch-tone telephone keypad to remotely arm the

system.

If you hear modem tones when the control panel answers the incoming call, this

means that the system has been programmed for remote programming functions by

your installer. Simply wait for a pause between the tones before pressing the * button.

Two beeps will be heard to indicate that the system has been armed in AWAY Mode.

3. Hang up the telephone and the system will remain armed.

Note

If your installer has programmed answering machine bypass, you will need to call the

control panel twice to make a connection with the system (eg. Call the telephone

number that your control panel is connected to and let the call ring no more than 4

rings and then hang up the telephone. Wait a minimum of 8 seconds before you call

the control panel back again).

24 !"#$%&"'()* Operators Manual

ISSUE160.DOC Electronics Design and Manufacturing Pty Limited

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

Sin comentarios

Bosch Solution 16plus Especificaciones Pagina 24