Bosch Solution 16plus Especificaciones descargar pdf (Pagina 33)

Term Description

Hand Held Remote

Control

Can be used to remotely operate your system via hand held transmitters (Also

known as RF keyfobs).

Isolating

Allows you to manually disable (isolate) one or more zones before arming the

system.

Master Code

Is a numerical code used for arming and disarming the system as well as allowing

access to functions such as adding and deleting user codes etc.

Master Partitioned

Codepad

This codepad can only be used if your system has been partitioned (CC488 Only).

The codepad allows you to view and operate both areas from the same codepad.

Monitoring Station

Is a secure location where a digital receiver monitors numerous alarm systems and

deciphers their alarm transmission reports. The operator can then advise the

appropriate authorities to take immediate action.

Panic Alarm

This type of alarm indicates to the monitoring station that there is an emergency

situation at your premises.

Phone Controller

The phone controller can be used to turn your system on in AWAY mode via the

telephone by generating a tone.

Sealed

Refers to zone status. If a zone is sealed, the detection device is not violated an

the zone indicator will not be displayed on the codepad.

Sensor Watch

Sensor watch gives the control panel the ability to recognise that detection devices

may have stopped working or that the view to a PIR detector has been blocked,

thus unable to detect any movement over the duration of the time programmed by

your installer.

Silent Alarm

Your installer may program zones for silent operation. This means that when the

zone programmed for silent operation has been violated during the armed period,

your alarm system will communicate with the monitoring station without sounding

the sirens.

STAY Mode 1

Is a condition that automatically isolates zones when your system is armed in

STAY Mode 1. Only your installer can program zones to be isolated automatically

in STAY Mode 1.

STAY Mode 2

Is a condition that automatically isolates zone when your system is armed in STAY

Mode 2. Only the Master Code holder can program zones to be isolated

automatically in STAY Mode 2.

Telco Arm Sequence

Telco arming is a feature that automatically calls the telephone exchange an

diverts your telephone number to another telephone when the system is armed in

AWAY Mode (In Australia, this feature is called “Call Forward”).

Telco Disarm Sequence

Telco disarming automatically calls the telephone exchange and un-diverts you

telephone number.

Unsealed

Refers to zone status. A zone is unsealed when a zone has been violated. The

corresponding zone indicator will display on the codepad.

!"#$%&"'()* Operators Manual 33

Electronics Design and Manufacturing Pty Limited ISSUE160.DOC

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 43 44

Comentarios a estos manuales

Sin comentarios

Bosch Solution 16plus Especificaciones Pagina 33

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch Solution 16plus