Bosch HTS 62 Manual de usuario descargar pdf (Pagina 24)

24 en | Programming steps Configuration Manager

970.129b | V2 | 2014.05 User Manual Bosch Security Systems

63. Acoustical feedback for technical failures

The Carephone 61/62 can be set to announce technical failures through

the LED lamps and the loudspeaker, or through the LED lamps only.

– 0 = loudspeaker off

– 1 = loudspeaker on. This is the default value.

– 2 = loudspeaker on from 7:00 to 21:00

– 3 = an acoustical failure indication (message or beep) is repeated with

a pause of 10 seconds until the Action button is pressed.

– 4 = an acoustical failure indication (message or beep) is repeated

during day time (from 7:00 to 21:00) with a pause of 10 seconds until

the Action button is pressed.

Settings 2 and 4 are only available if the time and date are set. This can be

done through keyboard programming, Configuration Manager with serial

serial connection or via a remote date/time update from a receiver.

77. Pre-alarm time

The pre-alarm time of the Carephone 61/62 can be programmed. This is

the time frame in which an emergency call can still be stopped.

– Select a setting, in steps of 10 seconds, between 0 and 6.

– 0 = off, 1 = 10 s, 2 = 20 s, etc. Default value is 1.

24. Confirmation with call

When the repeated emergency call has been locally acknowledged, you can

speak directly to the monitoring centre.

27. Presence marking - Service done

The presence marking function allows staff members to mark their

presence or signal that the service is done by pressing the daily button.

This is handled without a speak/listen connection and does not require an

answer by the operator. When the presence marking is activated, the

destination numbers to be called are set in the call sequence of step 58 of

the tab Function assignment. This function resets the activity monitor,

which must be set. See step 40 of the tab General.

02. CPC Adaptation

You can set the Carephone 61/62 to use a specific CPC adaptation when

the CPC protocol is used. Check the tick-box to enable this function.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

Sin comentarios

Bosch HTS 62 Manual de usuario Pagina 24