Bosch LTC 8555 Manual de instrucciones descargar pdf (Pagina 21)

Bosch Security Systems | December 8, 2004

LTC 8100, LTC 8200, LTC 8300 Series | Instruction Manual | Installation Procedure

To maintain a sense of order, it is preferable to program a

satellite for a range of camera numbers. For example, in a

three Allegiant type satellite system, the first satellite can

be programmed for camera numbers 1 to 50. Satellite

two can be programmed for camera numbers 101 to 131,

and satellite three can use numbers 201 to 225.

If necessary, the MCS or GUI software Keyboard-to-

Monitor Lockout table can be programmed in the

satellite switcher to prevent any local operators from

inadvertently accessing the satellite’s monitor outputs

being used as trunk lines.

If operators will be stationed at the satellite site, camera

titles should be entered into the switcher. If desired, these

titles can be selected (explained below) to appear at the

main site.

The only other requirement is to ensure that the Console

ports of all Allegiant type satellites have the handshake

option disabled (CTS = off). This is done via keyboard

User Function 30 (see Section 13, KEYBOARD USER

FUNCTIONS), the MCS or GUI software’s Parameters-

System screen.

6.9.5 Main Site Programming Requirements

At the main site, the Camera ID table must be

programmed to ensure proper satellite operation. It is

easiest to start with the trunk line inputs. For each trunk

line, the satellite’s monitor output number and its bay

address must be entered (same number as the satellite’s

LTC 8780 address).

Camera numbers should be programmed next. No

duplicate camera numbers are allowed anywhere in the

entire system. Designate remote cameras (located at

satellite sites) using numbers above those at the main

bay’s physical video inputs (9+ on LTC 8100 Series,

17 + on LTC 8200 Series, 33+ on LTC 8300 Series,

65+ on LTC 8500, 129+ on LTC 8600, 257+ on

LTC 8800 Series, 4097+ on LTC 8900 Series). Enter the

desired camera number, (the satellite bay that it is

actually connected to), and select if either a local title will

be used, or if the remotely generated title will be used.

For satellite camera entries, only those numbers

representing actual cameras need to be entered. For

example, all 16 cameras associated with an LTC 8200

switcher do not need to be entered if only 5 cameras are

actually connected to the switcher. If desired, a few extra

camera numbers may be included at this time for future

expansion. If a local title is specified, the camera’s title

can also be entered at this time. Designate any local

camera numbers appropriately, and enter their

corresponding titles.

NOTE: Either a local camera, or a remote camera

programmed with a local title, will need to be selected to

view certain on-screen prompts or data during

programming of the main site via a system keyboard.

Once the system is programmed and configured, any

unused monitor outputs located at the main site should

be selected to display a local camera via the system

keyboard. This prevents unused monitor outputs from

using up trunk lines which may result in some confusing

operational responses.

BOSCH

Figure 6 Front Panels: LTC 8300 Series - Top, LTC 8200 Series, LTC 8100 Series - Bottom

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 63 64

Comentarios a estos manuales

Sin comentarios

Bosch LTC 8555 Manual de instrucciones Pagina 21

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch LTC 8555