Bosch LTC 8555 Manual de instrucciones descargar pdf (Pagina 57)

Bosch Security Systems | December 8, 2004

LTC 8100, LTC 8200, LTC 8300 Series | Instruction Manual | Appendix A Satellite Systems

Since Allegiant Series switchers can act as Main site

switchers, they provide additional logical camera

numbers for identifying the location of the satellite

camera inputs in the system. These logical camera

numbers can also be used to provide titles which

would appear on the Main site’s monitors for any

remote cameras. Since each camera (anywhere in the

system) must have a unique camera number, logical

camera numbers together with physical camera inputs

make up the total system camera capacity. Thus, there

is a trade-off between the total number of Main site

cameras and the number of inputs used as trunk lines.

The more inputs used as trunk lines, the fewer there

are for use as direct camera inputs.

*Camera inputs at all sites, plus trunk lines.

The Main site system must be programmed via

the Master Control Software for Windows

LTC 8059/00 or the LTC 8850/00 GUI, to identify

camera trunk line inputs as well as remote satellite

cameras. All systems must be configured with no

duplicate camera numbers anywhere in the system.

Any alarm inputs to the Main site configured to

activate satellite cameras operate normally except

when limited by the number of available trunk lines.

The software automatically determines trunk usage,

depending on the priority level of operators currently

viewing satellite cameras. Alarm inputs applied at a

satellite site will NOT activate alarm video at the Main

site. If the application requires alarms located at a

satellite to activate video at the Main site, the Main

site’s LTC 8540/00 Alarm Interface unit must be

remotely located. Multiple LTC 8540/00 Alarm

Interfaces may be remoted via the LTC 8713 Alarm

Port expander accessory, located at the Main switcher

site in LTC 8800 and LTC 8900 systems. Up to 2

LTC 8540/00 Alarm Interfaces with a LTC 8713 Alarm

Port Expander can be used in a LTC 8600 system.

One LTC 8540/00 can be used in LTC 8500 systems.

Since the LTC 8100, LTC 8200, and LTC 8300 Series

contain an integral alarm interface, the remote alarm

interface application does not apply.

A unique time and date synchronizing feature

provided in the Time Event table of the MCS for

Windows or the GUI software may be programmed

into the Main site switcher. This permits periodic

synchronizing of the time and date to all switchers in

the system based on the Main site’s clock.

A conceptual diagram of a satellite switching system is

follows.

Model No. Maximum Number* System Cameras

LTC 8100 Series 264

LTC 8200 Series 272

LTC 8300 Series 288

LTC 8500 Series 320

LTC 8600 Series 1152

TC 8700 Series 2304

LTC 8800 Series 2304

LTC 8900 Series 4608

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 63 64

Comentarios a estos manuales

Sin comentarios

Bosch LTC 8555 Manual de instrucciones Pagina 57

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch LTC 8555