Bosch LTC 8555 Manual de instrucciones descargar pdf (Pagina 22)

Bosch Security Systems | December 8, 2004

LTC 8100, LTC 8200, LTC 8300 Series | Instruction Manual | Installation Procedure

6.9.6 Alarm Inputs in Satellite Systems

Any alarm inputs to the main site, which have been

programmed to activate cameras located at satellites, will

operate normally except when limited by the number of

trunk lines available. The software automatically

determines trunk usage depending on the priority level of

operators currently viewing satellite cameras. Alarm

inputs applied at a satellite site will NOT activate alarm

video at the main site. If the application requires alarms

located at a satellite to activate video at the main site, the

remote alarms must be brought back to the main site. If

necessary, the main site’s LTC 8540/00 Alarm Interface

unit can be remotely located via an RS-232 link. Since

the Alarm Interface capability is an integral part of the

LTC 8100, LTC 8200, and LTC 8300 Series, this is not

possible if an LTC 8100, LTC 8200, or LTC 8300 Series

system is being used as the main site system. If more than

one satellite site contains alarms, multiple LTC 8540/00

Alarm Interfaces can be remotely located. The number of

alarm interfaces which can be remoted is limited only by

the capacity of the main site system to support this

capability.

6.10 Feature Selection

Certain user-selectable features can provide enhanced

Allegiant system operation capabilities. Any changes

involving configuration option DIP Switch Settings should

be made prior to installation. Refer to FACTORY

DEFAULT SETTINGS Section for feature descriptions and

instructions.

6.11 Main Power Connections

Connect the AC power cord to an appropriate AC power

source. Verify that the selected LTC 8100, LTC 8200, or

LTC 8300 Series model matches the desired voltage

input.

NOTES:

• The system may require several seconds to fully

initialize after a power up reset. This time can vary

based on the activity and general size of the

system. Verify that the front panel POWER LED

lights and the front panel STATUS LED begin to

blink randomly.

• ALL CAMERAS SHOULD BE PHASED

PROPERLY WITH EACH OTHER TO

AVOID VERTICAL ROLLING MONITOR

DISPLAY DURING SWITCHING.

•THE SYSTEM IS DESIGNED TO PROVIDE

VERTICAL SYNCHRONIZED SWITCHING

BASED ON THE MAIN VOLTAGE INPUT

FREQUENCY.

Proceed to the next applicable accessory installation

section or immediately to the appropriate system

operating instruction section.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 63 64

Comentarios a estos manuales

Sin comentarios

Bosch LTC 8555 Manual de instrucciones Pagina 22

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch LTC 8555