
FLIR
32-6 Camera Handler Release Notes
Camera limitation:
Dual streaming H264/H264 or
MPV4/MPV4 gives an error
message; "Could not updated
stream 1 video codec"
This is expected behavior due to
the Camera limitation for
Supported Codecs.
The camera does not support H264/H264
or MPEG4/MPEG4 combinations.
Therefore the NVR will provide an Error
message as expected when a Users tries
to configure these settings.
Due to the VE NVR VE API limitation,
the NVR Web Gui will show all three
resolutions on the 2
nd
Stream.
However only MJPEG is supported
on the second stream and so only
MJPEG as the second stream can be
used for dual streaming.
See table below stating the
Supported Dual Stream
Configurations & Resolutions
Issues with MP4V configuration
for Single and Dual Streaming.
If a User tries to configure the
MPV4 Stream for Single or Dual
Streaming Configuration the
settings may not apply.
MPV4 codec configuration for Single or
Dual Streaming may not configure
correctly.
Users are recommended to limit the
codec settings to H264 and MJPEG.
Users are not recommended to use
MPV4 codec for Single or Dual
Streaming configuration.
Please refer to the table below on the
Limitation on Configuring on MPV4
Codec for Single or Dual Stream(s)
Resolution list on the VE NVR is
not correct for the second stream
(MJPEG).
Due to changes to the supported
resolutions of 2
nd
stream on both
IR/DLTV Lens, unsupported resolutions
appear in the resolution list for the
second stream.
See table below stating the
Supported Dual Stream
Configurations & Resolutions.
Users should only open one
preset control at a time
When adding/editing presets on IR/DLTV
lens, user must close the preset controls
on the other lens.
On device list page for D-324 the
firmware is showing as 2.5.13.3
instead of 2.5.16.0 which is
reflected on the Camera Web
GUI
Cosmetic issue from the camera. Camera issue: Cosmetic issue from
the camera sending the information
to the VE NVR.
Issue Description Comment
Comentarios a estos manuales