Bosch SF8172V Especificaciones descargar pdf (Pagina 97)

AXIS Communications

28-10 Camera Handler Release Notes

6 This audio only device cannot be live viewed in VE

Hybrid/ local client as audio devices cannot be selected

for surveillance. It is recommended to associate the

device (via associate audio setting in NVR) with a

camera which streams video.

7 Audio volume cannot be changed via the NVR audio list

page. If necessary, user should adjust using the camera

GUI or victor volume control.

8 When recording is enabled via the NVR audio list for this

device, audio will not stream live or recorded. In order to

enable recorded audio, the device should be associated

to a video stream via the NVR Function & Streams page.

(Select Advanced edit of a Device supporting Video

Stream -> Select Associate Audio drop down -> Select

the P8221 audio device)

M1054 Although there are two dry contact inputs on NVR web page, the

second dry contact input is used for the PIR sensor and therefore

cannot be used as a dry contact input alarm source.

M3007 1 Adding M3007 to the NVR will add up to 6/8 streams. As

this camera has a maximum FPS of 12, adding too many

streams would cause FPS to decrease further. When all

channels are added to the NVR, the FPS decreases -

deleting some of the streams will increase FPS on the

remaining configured streams.

2 Changing image settings on one channel on the M3007

will be applied to all channels.

3 The camera mode should be set before adding M3007 to

NVR. When changing the camera mode the camera

should be deleted from the NVR and re-added after

camera has been configured.

4 If the M3007 camera mode is set to “wall mount” 6

channels will be added to the NVR. However, if the

M3007 is set to “ceiling mount” 8 channels will be added

to the NVR.

5 If required, The rotate image should be set on camera

before adding into NVR.

6 If there is frame loss overnight, it may cause a quick

flicker to occur during video. Downloading the video clip

will not show any video loss.

7 If frame loss is experienced overnight, it may cause a few

second video freeze.

8 On the NVR, Edge Based Motion Detection/Edge Based

Meta Data can only be configured on channel 1 – the

Overview/Fisheye channel. This is because the camera

itself configures motion detection on the

Overview/Fisheye stream; which adds to the NVR as

stream 1

Q6035 If running a sequence overnight, it is recommended to use a

FPS>5 setting. If saved at a lower FPS, any frame rate drops

may cause the video to freeze during sequence run.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 174 175

Comentarios a estos manuales

Sin comentarios

Bosch SF8172V Especificaciones Pagina 97

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch SF8172V