Bosch SF8172V Especificaciones descargar pdf (Pagina 98)

AXIS Communications

28-

Known Issues

All cameras Should a camera become network disconnected for an extended

period of time (More than 12 hours) the NVR may not receive

edge based motion events/ dry contact events. If this occurs it

may be necessary to disable and re-enable dry contacts and

edge based motion detection again via the NVR interface.

P1357 The maximum FPS changes according to how the camera is

config

ured. See camera user manual.

M3007 The “Mount Type” is not shown on NVR.

Due to a camera firmware issue, af

ter restarting the camera,

channel 8 restores to default settings.

P1357, M3007 Stream settings should be configured on NVR before enabling

Edg

e Based Motion Detection. Once added to the NVR and

enabled, changing the settings may cause video stream lost. If

this issue occurs, the camera must be removed from the NVR,

factory defaulted and re-added to the NVR.

Note

Please refer to AXIS cameras release notes published on the AXIS website for more information

about AXIS cameras and limitations.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 174 175

Sin comentarios

Bosch SF8172V Especificaciones Pagina 98