Bosch SF8172V Especificaciones descargar pdf (Pagina 141)

Panasonic Corp

34-8 Camera Handler Release Notes

NW960, NW964, NS950,

NS954

Due to a Camera limitation, Patterns cannot be cancelled during its set up phase.

The "X" button is recommended not to be used in this case and the user should

instead use the Stop button. If the user does click on the "X" button, the user

should wait till the counter counts down to zero. The user can then add the pattern

again using the start and stop buttons

Due to camera limitation, the pattern learning process cannot be cancelled and

stopped during adding a pattern via Victor client. User can do subsequent pattern

operations until the learning process completed.

NW964

It has been rarely observed that the camera may reboot, when creating/editing a

preset or pattern operation with Victor client.

Due to the camera limitation on its API, the active statuses of the second and third

dry contact are not available. They are just showed as "NA" on the NVR web

page.

ST162, ST165

In Victor client, if user does a quick nudge of the pan/tilt button, the pan/tilt will

keep on moving until it reaches its axis limited

During PTZ control on the ST165 the motor will cause a lot of noise via the internal

mic, The audio output will be muted automatically by the camera at that time. User

can either use the external mic and/or disable this muting feature via camera web

page. Refer to the camera operation manual for the details.

SF132, ST152, SC385

It has been rarely observed that there may be 5 seconds of video loss on the

MJPEG stream of these cameras due to the camera firmware issue.

SF132

Due to the camera limitation, the Back Light Compensation setting will

automatically become 0 after changing the Wide Dynamic Range.

SW314

In rare cases SW314 PTZ details page on NVR web GUI may wrongly display the

"Enable PTZ" button. After refreshing the page, the button will disappear.

GXE500

This camera will only support one stream configuration for these codec across all

streams. It means that changing the stream configuration of any one channel will

affect all channels. If the dual stream of H.264 or MPEG4 is enabled, changing

one stream configuration will affect another.

This encoder will only support a single audio stream which out handler will

associate with the first channel.

Due to performance limitation, Panasonic limits the stream by number and

bandwidth, to avoid stream loss it is recommended to lower the codec bitrate on

the camera GUI

Though the encoder supports 256 presets, only 255 presets can be set by Victor

client this is a victor client issue to do with the video overlay.

Due to the slow response from the camera, the active status of some of the dry

contacts will appear as "NA" on the NVR web page. If the web page is refreshed

then the normal status will show.

Encoder firmware v1.36 does not support Pelco-P protocol. Therefore it is

recommended to upgrade to encoder firmware v1.40 which support Pelco-P

protocol.

The default Pan/Tilt speed Panasonic provided in the Pelco-D protocol file for

GXE500 is relatively slow. It is recommended to change the speed in the protocol

file before uploading the file into Encoder. Please refer to the Panasonic GXE500

Installation Guide for details.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 174 175

Comentarios a estos manuales

Sin comentarios

Bosch SF8172V Especificaciones Pagina 141

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch SF8172V