Bosch K2200 Series Guía de instalación descargar pdf (Pagina 23)

K2200 Series | Installation Guide | 5.0 Installation Details EN | 23

Bosch Security Systems | 7/03 | 17375 1.3 / 46513C

Power Supply

The metal cased power supply unit is fitted on the

left-hand side of the baseplate. This unit will

automatically adjust to the local AC power supply,

accepting input voltages between 85 VAC and 250

VAC at 50/60 Hz. The power input uses a standard

IEC connector; a right-angle socket is supplied.

The output from the power supply is fed to the

circuit board by an 8-pole connector.

Faceplate

The removable faceplate, if fitted, contains a key

reader, on the left-hand side, a keypad and a 16

character display. The panel is secured by two tabs

that fit into slots in the power supply on the left-hand

side of the baseplate, and by two spring clips on the

right-hand side of the panel that attach to the

baseplate. A ribbon connector plugs into a socket on

the circuit board at the top right of the board.

The faceplate and controller can be purchased as

separate items but it is recommended that only slave

controllers are purchased without a faceplate. There

should be at least one controller (master) on a site

with a faceplate.

Memory Module

This small board sits on top of the cover plate and

contains the software and database memory. A small

removable battery maintains the database memory

for six months in the absence of mains or battery

power.

5.2 Introduction

This is a brief outline of the steps that will be taken in

the following sections. This describes the installation

and testing of the door controller independently of

the administration system.

It is possible to test all the reader and lock functions

before making any network or communications

connections. You are strongly advised to follow the

order shown below. In this way you will be able to

identify any problems before going on to the next

stage.

1. Sitting and Fitting the Controller, including

fitting of the Readykey metal case if used.

2. Installation of Readers, including door contacts,

request-to-exit switches.

3. Wiring of Locks

4. Testing of Readers, Locks etc.

5. Network connections, six-wire bus and/or serial

links where applicable.

Note:

Further information on administering the K2200 is

included in Readykey K2200 Series Controllers User

Guide (Radx P/N: 47491, PAC P/N: 17376).

5.3 Installing the Controller

The door controller may be mounted in the metal

case (part number K2120 of D8103) supplied

separately by Bosch Security. Make sure that access

can be gained to the door controller independently of

the access control system itself.

If several door controllers are to be connected using

the six-wire bus, it is usually better to distribute the

controllers so they are closer to the doors. This

should reduce the length of cable needed for readers

and locks.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 59 60

Comentarios a estos manuales

Sin comentarios

Bosch K2200 Series Guía de instalación Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch K2200 Series