
K2200 Series | Installation Guide | 5.0 Installation Details EN | 30
Bosch Security Systems | 7/03 | 17375 1.3 / 46513C
5.4 Installing Readers and Locks
All the features described below can be
programmed and tested, where
necessary, at the faceplate. Details of
how to do this are given in Section Error!
Reference source not found.. However, if
the door controller is going to be
administered from a PC-based system,
you will need to program these features
from there as well. You are advised to
use the faceplate to test the installation of
the door controller, readers and locks and
then, once communications are
established, initialize the door controller
and program the features at the
administration PC.
How to fully commission a PC-based system is
described in the documentation supplied for that
system.
5.4.1 KeyPAC K3000 Series Readers
These readers read KeyPAC electronic keys and ISO
thickness ID cards they do not read the earlier
Readykey ID devices. Make sure that you specify
KeyPAC whenever you purchase electronic keys and
ID cards.
KeyPac Low Profile Reader - K3001 + K3001W
A reader suitable for interior or exterior use and
comes in both black and white.
KeyPac Vandal Resistant Reader - K3002 +
K3002B
A stainless steel or brass reader particularly suitable
for exterior use, where resistance to abuse is
important.
KeyPAC Mullion Reader - K3003 + K3003W
This device is a slimline version of the low profile
reader, suitable for mounting on door frames etc.
Comes in both black and white.
KeyPAC Extended Range Reader - K3004 +
K3004W
This device is weather resistant and suitable for
indoor and outdoor use. Keys and Cards are read at
a distance of up to 10 inches. Comes in both black
and white.
5.4.2 K2000 Series Readers
These readers read Readykey ID electronic keys and
ID cards. They do not read the newer KeyPAC
elctronic keys and ID cards. Make sure that you
specify PAC ID (not KeyPAC) whenever you
purchase electronic keys and ID cards.
Readykey Low Profile Reader - K2001 + K2001W
A reader suitable for interior or exterior use and
comes in both black and white.
Readykey PIN Reader and Readykey Surface
Mount - K2001-P
This device requires a PIN number to be entered, as
well as a key to be presented, as an extra level of
security. The need to use a PIN as well as a key can
be controlled using a time profile.
Readykey Vandal Resistant Reader - K2002 +
K2001B
A stainless steel or brass reader particularly suitable
for exterior use, where resistance to abuse is
important.
Readykey Mullion Reader - K2003 + K2003W
This device is a slimline version of the low profile
reader, suitable for mounting on door frames etc,
comes in both black and white.
Readykey Panel Reader- K2025
A reader designed for mounting in a steel panel, such
as a door entry system or elevator cabs.
KeyPAC ID Devices
The KeyPAC range will not work with the earlier
Readykey devices. The following are part codes for
compatible electronic keys and ID cards:
• K3010-10- KeyPAC Prox Keys, packs of 10
• K3011-10- KeyPAC Prox Cards, packs of 10
• K3011M-10- KeyPAC Prox Cards with Magnetic
Stripe, packs of 10
Readykey 2000 Series ID Devices
The K2000 Series devices will not work with the
newer KeyPAC devices. The following are part codes
for compatible electronic keys and ID cards:
• K2010-10- Electronic Key, packs of 10
• K2011B-10- Cards with logo, packs of 10
• K2011M-10- Cards with Magnetic Stripe, packs
of 10
• K2011W-10- Cards, White (no logo), packs of 10
The Readykey K2200 Series Controllers have either
four or two reader channels. Each reader is wired
independently using up to 3000 ft. (1000 m) of 6-
conductor cable.
Comentarios a estos manuales