Bosch K2200 Series Guía de instalación descargar pdf (Pagina 6)

K2200 Series | Installation Guide | 1.0 Introduction EN | 6

Bosch Security Systems | 7/03 | 17375 1.3 / 46513C

1.5 Listings and Approval

1.5.1 FCC Notice

This equipment generates and uses radio frequency

energy. If not installed and used in accordance with

the manufacturer's instructions, it may cause

interference to radio and television reception. It has

been tested and found to comply with the

specifications Subpart F of Part 15 of FCC rules for

Field Disturbance Sensors. If this equipment causes

interference to radio or television reception - which

can be determined by turning the equipment on and

off - the installer is encouraged to correct the

interference by one or more of the following

measures:

1. Reorient the antenna of the radio/television,

2. Connect the AC power cord to a different outlet

so the control panel and radio/television are on

different branch circuits,

3. Relocate the control panel with respect to the

radio/television.

If necessary, the installer should consult an

experienced radio/television technician for additional

suggestions, or send for the "Interference Handbook"

prepared by the Federal Communications

Commission. This booklet is available from the

U.S. Government Printing Office,

Washington D.C. 20402,

stock no. 004-000-00450-7.

FCC Registration Number: IDHM32Y6K2000

1.5.2 UL Listing

UL 294 - Access Control System Units

When installing the K2200 series

controllers the following should be noted:

1.5.3 HEALTH AND SAFETY

It must also comply with any local Fire, Health and

Safety regulations. A secured door that may be part

of an escape route from an area must be installed

with:

• A fail-safe lock (A). So that the door will

be released if the power fails. Ideally a

magnetic lock should be used as these

are less likely to jam or seize.

• A normally-closed break-glass or manual

pull (B) in the lock supply wiring. So that

in an emergency the fail-safe lock can be

immediately powered down.

Figure 1: Failsafe Lock Wiring

The controller must be grounded.

Disconnect both ac and battery power supply before

working on the controller.

1.5.4 CABLING

The cabling used in the Readykey access control

systems (six wire bus, reader cables, etc.) are not

prone to electrical interference. However, you should

avoid routing cable close to heavy load switching

cables and equipment. If this is unavoidable, cross

the cable at right angles every 3.3 to 6.6 ft (1 to 2 m)

to reduce the interference.

1 2 3 4 5 6 7 8 9 10 11 ... 59 60

Comentarios a estos manuales

Sin comentarios

Bosch K2200 Series Guía de instalación Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch K2200 Series