Bosch K2200 Series Guía de instalación descargar pdf (Pagina 26)

K2200 Series | Installation Guide | 5.0 Installation Details EN | 26

Bosch Security Systems | 7/03 | 17375 1.3 / 46513C

Figure 13: Rear View of Door Controller Base Plate

5.3.4 Power Supply

The database is stored in battery-backed

memory and will be preserved whether

the controller is powered or not. This

backup will last up to 3 years provided

that the controller is normally powered.

The battery, located on the memory

module, can be replaced without losing

data. This is recommended every 3 years.

Note:

The backup will be preserved for 6 months if the

controller is not powered.

AC Supply

AC power, between 85 VAC and 250 VAC, 50/60

Hz, should be supplied to the controller through an

illuminated, unswitched outlet. A right angle IEC

plug is supplied.

A GROMMET MUST BE FIXED TO THE

HOLE THROUGH WHICH THE AC

POWER WOULD PASS. THIS IS TO

PREVENT THE METAL CASE CUTTING

THE AC LEAD IF THE LEAD IS PULLED

ON.

Power Indicator

A red LED is situated within the power supply. It is

visible through a small hole about 3 in. (75 mm) from

the top on the left-hand side of the power supply

case.

If the door controller is operating off the AC power

supply, whether the battery is connected or not, the

LED will be lit.

If the AC power supply fails and the unit is running

from the backup battery, the LED will be

extinguished.

5.3.5 Lock Output Voltage

The lock output voltage is set for all doors on the

controller using a switch accessible through the top

edge of the power supply. 24VDC allows 1 amp of

current draw per output, 12VDC allows 2 amps of

current draw per output.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 59 60

Comentarios a estos manuales

Sin comentarios

Bosch K2200 Series Guía de instalación Pagina 26

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch K2200 Series