Bosch AMAX panel 4000 EN Guía de instalación descargar pdf (Pagina 23)

RF 3227E RF Receiver

Brief Introduction

The RF3227E RF Receiver allows the use of wireless devices using AMAX panel 4000.

Installation

Considerations

The receiver should be mounted in a central location in regard to all wireless sensors,

whenever possible.

The receiver should be mounted vertically with at least 25 cm clearance above it for the

antennas.

Avoid mounting the receiver in areas with significant metal or electrical wiring such as furnace

rooms or utility rooms. If this is unavoidable, mount the receiver with the antennas extending

above any metal surface.

Avoid mounting the receiver in areas where it may be exposed to moisture.

Reception distances are generally improved with higher mounting locations and with no metal

objects near the antennas.

Setting Up the Wall Tamper

Notice!

If not using the wall tamper, proceed to Mounting the Receiver, page 24

To enable the wall tamper switch:

– Remove the cover of the receiver (see Figure 5.13).

Insert screwdriver here and press in.

Figure 5.13: Removing the Cover

– Remove the inner cover by pressing the latch.

Press latch

to remove

the inner cover.

Cover

Tamper

ADDR

Figure 5.14: Removing the Inner Cover

– Move the wall tamper jumper as shown in Figure 5.15.

5.6

5.6.1

5.6.2

AMAX panel 4000 / AMAX panel 4000

Optional Modules and Peripheral Devices | en 23

Bosch Sicherheitsysteme GmbH Installation Guide 2013.07 | 03 | F.01U.267.112

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 175 176

Sin comentarios

Bosch AMAX panel 4000 EN Guía de instalación Pagina 23