Bosch AMAX panel 4000 EN Guía de instalación descargar pdf (Pagina 30)

Danger!

Special care is required in connecting the positive (red) wire and the “BATT +” port of the

alarm control panel. If short-circuiting with the “BATT +” port of the alarm control panel or the

enclosure, electric arc will occur. To remove the battery from the control panel, the positive

wire of the battery should be disconnected first.

1. Place the battery on the bottom of the module.

2. Position the red and black wires supplied with the battery.

3. Connect one end of the black wire to the "BATT -" port of the alarm control panel, the

other end to the negative (-) pole of the battery.

4. Connect one end of the red wire to the "BATT +" port of the alarm control panel, the

other end to the positive (+) pole of the battery.

After the backup battery and the main power are connected, once the installation is

completed, the alarm control panel will began to charge the battery.

Red Lead

Black Lead ( - )

Backup Battery

Figure 6.2: Connection of Battery

System Power Up

After the system is powered up, set date and time. Otherwise, the system prompts as fault.

After the system is powered up or reset, it resets to previous arming / disarming status.

To reduce false alarms caused by system power-up (or by power supply restoration after both

mains supply and AUX power supply fail), the system is designed to not perform zone test

within one minute after power-up.

6.3

30 en | Installation

AMAX panel 4000 / AMAX panel 4000

2013.07 | 03 | F.01U.267.112 Installation Guide Bosch Sicherheitsysteme GmbH

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 175 176

Sin comentarios

Bosch AMAX panel 4000 EN Guía de instalación Pagina 30