Bosch TOURING 7500 SERIES Manual del operador descargar pdf (Pagina 171)

Load balancing is configured automatically. Each encoder is automatically assigned

2 iSCSI targets and blocks on these 2 iSCSI targets are assigned to the encoder.

Sanity check period (days)

Move the slider to configure the required time period. After this time period the iSCSI target is

checked and blocks are reassigned if needed.

Secondary target usage

Enable or disable the use of a secondary target.

Block reservation for downtime

Enter the number of days that the assigned encoders will be recorded although the

VRM Server is down.

For example, if you set 4, the encoders will be recorded during approximately 4 days of

VRM Server downtime.

If your system has encoders with low bit rate, you can significantly reduce the pre-allocated

disk space. This ensures a proper distribution of storage capacity and extends the retention

time.

Further information

– iSCSI storage pool

Add Encoder / Decoder dialog box

Main window > Devices > Expand > Expand > Right-click > Click

Add Encoder > Add Encoder dialog box

Main window >

Devices > Right-click > Click Add Encoder > Add Encoder

dialog box

Main window >

Devices > Right-click > Click Add Encoder > Add Encoder

dialog box

Main window > Devices > Expand > Expand > Right-click > Click

Add Encoder > Add Encoder dialog box

Main window >

Devices > Expand > Right-click > Click Add Decoder >

Add Decoder dialog box

Allows you to add an encoder or decoder manually. This is especially useful when you want to

add any BVIP encoder (not for NVR).

IP address:

Type in a valid IP address.

23.27.1

Bosch Video Management System Devices page | en 171

Bosch Sicherheitssysteme GmbH Configuration Manual 2013.07 | V1 | Configuration Client

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 259 260

Sin comentarios

Bosch TOURING 7500 SERIES Manual del operador Pagina 171