Bosch TOURING 7500 SERIES Manual del operador descargar pdf (Pagina 76)

When you want to add devices that are not members of the same subnet, perform the initial

device scan.

To start the initial device scan:

1. On the Hardware menu, click Initial Device Scan....

The Initial Device Scan dialog box is displayed.

2. Click a cell to change the desired address. For changing multiple devices, select the

desired rows. You can select multiple devices by pressing the CTRL- or the SHIFT-key.

Then right-click the selected rows and click Set IP Addresses... or click Set Subnet

Mask... to change the corresponding values.

You must enter the correct subnet mask before changing an IP address.

3. Click OK.

To scan the network:

1. Click

The NVR & Decoder Scan dialog box is displayed and all available NVRs, decoders, and

encoders are detected.

The detected decoders are listed in the Decoders list and assigned automatically to the

tree item of the Device Tree. If no analog monitor group has already been created,

the detected decoders are added to a new analog monitor group under > .

If you do not want to use a decoder or an NVR, remove the item manually: right-click the

item and click Remove.

The detected NVRs are assigned automatically to the

tree item of the Device Tree.

2. In the Unassigned Encoders list, select an encoder and drag it to an NVR in the Assigned

Encoders and NVRs list. The encoder’s cameras are recorded on the selected NVR.

3. Repeat the above step for every detected encoder that you want to be part of your

system. Encoders that you do not drag to an NVR, are completely invisible in Bosch VMS.

4. Click Next >.

If required, a dialog box is displayed for changing the device names of the connected

devices of the detected IP devices to be used for display. Bosch VMS names the devices

with default names. If desired, you can use the existing names of the devices.

5. Make the required settings. For changing the displayed device names of a complete

column at once, right-click a column with check boxes and click Select Column.

6. Click Finish.

Configuring NVRs

Main window > Devices

This chapter provides information on how to configure NVRs in your system.

Primary NVRs record the images of all assigned encoders and IP cameras connected to your

system.

A Failover NVR is a server that takes over the tasks of a failing Primary NVR. The Failover NVR

starts recording as soon as the Primary NVR fails. A Failover NVR cannot have any encoders

directly assigned. A Failover NVR can take over the tasks of a Primary NVR even when

Management Server is not available.

12.2

76 en | Managing NVRs Bosch Video Management System

2013.07 | V1 | Configuration Client Configuration Manual Bosch Sicherheitssysteme GmbH

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 259 260

Comentarios a estos manuales

Sin comentarios

Bosch TOURING 7500 SERIES Manual del operador Pagina 76

Comentarios a estos manuales

Relacionado con productos y manuales para Grabadores de vídeo digital (dvr) Bosch TOURING 7500 SERIES