Bosch DS7445i Guía de usuario descargar pdf (Pagina 10)

PART II: KEYPAD USER’S GUIDE: DS7447i LCD KEYPAD

4.6 Turn the System Partial On

Exit Delay Time (to be filled in by your Security

Company):

You have __________ seconds to exit the premises.

Key Sequence: [#] + [3]

Description

Partial On turns on the portion of your system

designated as Partial, leaving the rest of the system

turned off. You can select the zones that turn on for

Partial On, whereas your Security Company

determines Perimeter Only zones. See “Set Partial

On Zones” for more information. Once you have

pressed [#] + [3], the Exit Delay countdown begins.

If there are faulted zones, they will appear on the

display. If they are Partial On zones, you must either

bypass them or return them to normal before turning

the system Partial On.

Smiths Residence

OK for Part On

Procedure

In the following example, 60 seconds is used for Exit

Delay. Exit Delay is set by your Security Company

and may vary from the example shown below.

1. Make sure that all Partial On zones are normal

(not faulted).

2. Enter a valid user PIN.

3. Press [#] + [3] to turn the system Partial On.

The Armed LED turns on. The keypad display

scrolls through the following:

60 seconds to

Partial On.

To bypass Zones

Press Bypass.

For no entry

Press No Entry.

For All On

Press On.

48 seconds to

Partial On.

Enter your PIN to stop the system from turning on

during Exit Delay. You can turn the system

Partial On with No Entry by pressing the [No

Entry] key, or you may bypass zones by pressing

the [Bypass] key.

During the last 10 seconds of Exit Delay, the

keypad allows for a “last chance” response to

disarm the system. During this time, the keypad

emits a double tone every second. The system

then turns Partial On. The Armed LED remains

on.

4. To turn the system off, enter a valid PIN.

4.7 Set Partial On Zones

I can perform this function.

I cannot perform this function.

Key Sequence: [#] + [6] + [5]

Description

Use this function to program which zones are armed

each time you turn the system Partial On. This allows

you to turn part of the system on to detect intrusion,

while the remaining part of the system allows you to

move freely without sounding an alarm.

Procedure

1. Make sure that the system is turned off (Armed

LED is off).

2. Enter a valid user PIN.

3. Press [#] + [6] + [5].

The keypad display scrolls through the following:

Zn 2 Part No

Front Door

Press 2 * for

Zn 2 Part Yes

Zn 3 Part Yes

Hallway

Press 3 * for

Zn 3 Part No

To exit

Press #.

4. Enter the Zone Number followed by the [*] key

that you want to toggle Yes or No for Partial On

operation. Repeat this step until all zones have

been programmed Yes or No for Partial On

operation.

• Yes: Zone is active, ready to detect intrusion

• No: Zone is not active.

5. Press [#] to exit this function.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 53 54

Comentarios a estos manuales

Sin comentarios

Bosch DS7445i Guía de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch DS7445i