Bosch DS7445i Guía de usuario descargar pdf (Pagina 12)

PART II: KEYPAD USER’S GUIDE: DS7447i LCD KEYPAD

The keypad display shows the following for

turning the system All On:

120 seconds to

All On.

To bypass zones

Press Bypass.

For no entry

Press No Entry.

The display shows the following for Perimeter

Only (display shows “Partial On” if the system is

turned Partial On):

120 seconds to

Perimeter On.

To bypass zones

Press Bypass.

For no entry

Press No Entry.

4. To turn the system on (All On, Perimeter Only or

Partial On) with no entry delay, press the [No

Entry] key. See page 11 for more information.

4.10 Force Arming the System

Force-arming is not permitted for UL

applications.

I can perform this function.

I cannot perform this function.

4.10.1 Force Arming with Normal Exit Delay and Exit

Tone

Procedure

1. Enter a valid user PIN.

2. Turn the system on using one of the following

methods:

• All On: Press [On] (or enter [#] +[1])

• Perimeter Only: Press [Perimeter Only] (or

enter [#] + [2])

• Partial On: Enter [#] + [3]

If a zone is faulted, the keypad displays the

following:

Zn 5 faulted,

Zone Text

To Bypass Zn 5

Press 5 + *

3. Re-enter the sequence from Step 2 that you used

to turn the system on (for example, if you press

[On] in Step 2, press [On] again). The following

message scrolls across the display:

Forced on!

60 seconds to

All On.

1 zones are

forced on.

The display above uses an Exit Delay time of 60

seconds and only one zone is force armed.

Exit Delay time and the number of zones force-

armed may vary.

4.10.2 Force Arming with Doubled Exit Delay and No Exit

Tone

1. Enter a valid user PIN.

2. Turn the system on using one of the following

methods:

Arming Function To Silence Exit Tone

Press and hold [On]

All On

Press [#], then press and hold the [1] key

Press and hold [Perimeter Only]

Perimeter Only

Press [#], then press and hold the [2] key

Partial On Press [#], then press and hold the [3] key

Table 7: No Exit Tone Key Sequences

3. When the “Zn Faulted” message appears (see

display under Step 2 of previous section), re-

enter the arming sequence used in Step 2 of this

section.

For example, if you turned the system on by

pressing and holding the [On] key, press the [On]

key again. Do not press and hold the key.

The “Forced On!” message appears and the

doubled Exit Delay countdown begins. The

keypad does not emit an Exit Tone.

The system forces the faulted zones on. As long as

they remain faulted they do not provide coverage. If

they return to normal before the system is turned off,

they provide coverage and are capable of starting

alarm events. If a zone becomes faulted after Exit

Delay begins, the keypad displays the faulted zone. If

the zone remains faulted at the end of Exit Delay, it

starts an alarm event.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 53 54

Comentarios a estos manuales

Sin comentarios

Bosch DS7445i Guía de usuario Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch DS7445i