Bosch DS7445i Guía de usuario descargar pdf (Pagina 28)

PART II: KEYPAD USER’S GUIDE: DS7447i LCD KEYPAD

4.38 Auto-Forward Off Setup

I can perform this function.

I cannot perform this function.

Key Sequence: [#] + [8] + [4]

Description

Use this function to program the Auto-Forward Off

sequence that cancels the redirecting of all incoming

calls to another telephone number when you turn the

system off.

Procedure

1. Enter a valid user PIN.

2. Enter [#] + [8] + [4].

The keypad then scrolls through the following:

Auto-Forward Off

Setup mode.

Enter digits for

Auto-Forward Off

For ‘pause’ (P),

Press On.

For ‘flash’ (F),

Press Perimeter

A and C keys

Move cursor.

To delete a digit,

Press B key.

To view and edit

Press Bypass.

To stop edit

Press Bypass

To exit

Hold #.

3. Enter the Auto-Forward Off sequence.

4. Press and hold the [#] key to exit this function.

4.39 Auto-Forward On/Off

I can perform this function.

I cannot perform this function.

Key Sequence: [#] + [8] + [2]

Description

Use this function to turn the Auto-Forward feature on

or off as necessary.

Procedure

1. Enter a valid user PIN.

2. Enter [#] + [8] + [2].

If Auto-Forward is already on, the keypad

displays the current status and any available

options. To turn Auto-Forward on, press the [1]

key. To turn it off, press the [2] key.

3. Press the [#] key to exit this function.

4.40 Remote Arming with Telephone, Area 1

I can perform this function.

I cannot perform this function.

Description

This function controls the built-in telephone arming

feature for Area 1. When enabled, the panel answers

the phone on the programmed ring count.

Procedure

When the panel answers the phone:

• If the panel is armed All On, Perimeter Only or

Partial On, it sounds three beeps and starts

the handshake tone for remote programming.

• If the panel is Off, it sounds one short beep,

waits approximately 3 seconds, and then starts

one long beep. Press and hold the [5] key* for

two seconds immediately after the first short

arming beep and before the long beep begins.

• The panel will arm if it detects a [5] key press

from the telephone (All On with Delay, faulted

zones are force-armed). The panel waits

sounds three beeps (new-armed state) and

then hangs up.

* If arming from a cell phone, quickly press the [5] key

three times. If pressing and holding the [5] key for two

seconds from a house (landline) phone does not

produce a tone long enough to arm Area 1, retry by

quickly pressing the [5] key three times.

Remotely disarming the panel cannot be done

with a telephone.

This feature is not permitted for UL

applications.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 53 54

Comentarios a estos manuales

Sin comentarios

Bosch DS7445i Guía de usuario Pagina 28

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch DS7445i