Bosch PIF6..T1.. Especificaciones descargar pdf (Pagina 28)

ECODRIVE Drive Controller DKC02.1

3-2 Warning Diagnostic Messages DOK-ECODRV-SSE-03VRS**-WAR1-EN-P • 12.96

Remedial action:

Verify motor rating. Check whether the drive conditions of a system that

has been used for a long time have changed in the meantime (pollution,

friction, moved masses, etc.).

E252 Bleeder Overtemperature Warning

Description: (see Cause:)

Cause:

The energy recovered from the motor loads the brake resistance in the

DKC to approximately 90%. The bleeder overtemperature warning

indicates that a bleeder overload must be expected if the recovered

energy continues rising.

Remedial action:

Reduce the acceleration values and/or the velocity, and check drive

rating.

E253 Target position out of travel zone

Cause:

For "drive-internal interpolation" mode, the system checks whether the

specified S-0-0258, Target Position is inside the possible travel range of

the drive. This is defined by the two parameters S-0-0049, Positive

position limit value and S-0-0050, Negative position limit value.

The message E253 is generated and the warning bit 13 in S-0-0012,

Class 2 Diagnostics set if the target position is outside the travel range.

Remedial action:

Check the specified S-0-0258, Target Position, and correct it if

necessary.

E254 Not Homed

Description:

If "absolute position blocks" are selected in "block-controlled mode", the

drive must be homed. An absolute position cannot be approached if this

is not the case. The drive rejects the positioning block and stops. This

warning is issued.

Cause:

An absolute positioning block has been selected without the drive being

homed.

Remedial action:

1. Home the drive

2. Select a "relative positioning block"

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 59 60

Sin comentarios

Bosch PIF6..T1.. Especificaciones Pagina 28