Bosch PIF6..T1.. Especificaciones descargar pdf (Pagina 54)

ECODRIVE Drive Controller DKC02.1

6-4 Exchanging Drive Components DOK-ECODRV-SSE-03VRS**-WAR1-EN-P • 12.96

Cable Exchange:

•

Turn off the main switch.

•

Ensure the drive will not be turned back on prematurely.

⇒

Danger of accident with life-threatening voltage

levels. Connect or disconnect the power connector

connections for the cables only if electrical power has

been turned off for the machine!

Note: When the cables are exchanged, open connectors from power

connections should be covered with protection caps to protect

against the spread of coolant, lubricating fluid or dirt (adm.

protection level V2).

Switchboard wall

Machine housing

V2 V2 V2 V2 V2

MKD

DKC

Immediate environment requirements

Conductive contamination cannot occur when operating the

control drive (at least not with the IP 65); when installing or

exchanging drive components, non-conductive contamination

or light condensation may momentarily occur.

AP5002F1.DRW

Fig. 6-2: Contamination level according to DIN VDE 0160

•

When exchanging cables, observe the machine manufacturer’s

directions.

⇒

Only connect the power connectors if they are dry

and clean.

Note: If you are not using assembled cables from INDRAMAT, check to

see if the new cables comply with the connection plan from the

machine manufacturer!

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 60

Sin comentarios

Bosch PIF6..T1.. Especificaciones Pagina 54