Bosch PIN8 N1 Guía para resolver problemas descargar pdf (Pagina 651)

100

101

MPH-02, MPB-02, MPD-02 Handling, Diagnostic and Service Functions 10-69

DOK-INDRV*-MP*-02VRS**-FK01-EN-P

trigger level

(P-0-0027)

trigger edge negative

(P-0-0030; bit 1 set)

control signal

status signal

end of recording

DK000049v01_en.fh7

time resolution

(P-0-0031)

start of recording

(P-0-0028, bit 0)

trigger start

(P-0-0029, bit 1)

number of valid measured

values (P-0-0150)

recording active

(P-0-0029, bit 0)

signal > trigger level

(P-0-0029, bit 8)

signal < trigger level

(P-0-0029, bit 9)

internal trigger

(P-0-0037, bit 0)

trigger function completed

(P-0-0029, bit 3)

no. of measured val. after

trigger event (P-0-0033)

delay function completed

(P-0-0029, bit 4)

trigger control offset

(P-0-0035)

external trigger signal

(P-0-0036)

Fig. 10-30: External trigger with offset measurement (P-0-0028; bit 1 = 1)

Note: The use of the external trigger source with trigger offset

determination is described in the section "Synchronizing the

Measuring Signals of Several Axes" (see below).

Selecting the Trigger Edges

In parameter P-0-0030, Oscilloscope: trigger edge it is possible to set

at which edge of the trigger signal the "internal trigger" is released. The

following options are available:

• triggering at the positive edge

• triggering at the negative edge

• triggering at both edges

• triggering when trigger signal equals trigger level

See Parameter Description "P-0-0030, Oscilloscope: trigger edge"

Trigger Edge (P-0-0030)

1 2 ... 646 647 648 649 650 651 652 653 654 655 656 ... 727 728

Comentarios a estos manuales

Sin comentarios

Bosch PIN8 N1 Guía para resolver problemas Pagina 651

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Bosch PIN8 N1