Bosch D7212GV2 Guía de instalación descargar pdf (Pagina 33)

D7212GV2 | Program Entry Guide | 2.0 GV2MAIN EN | 33

Bosch Security Systems, Inc. | 1/08 | F01U003804-04

Programming Ten-Digit Account Numbers

To program a ten-digit account number (such as

1122334455) using the D5200 Programmer, you must

enter a character for each of the ten digits. Refer to

Table 20.

Table 20: Programming Ten Digit Account

Numbers

D5200 Programmer

A# Acct# Dgt 1&2 1 1

A# Acct# Dgt 3&4 2 2

A# Acct# Dgt 5&6 3 3

A# Acct# Dgt 7&8 4 4

A# Acct# Dgt 9&10 5 5

The D5200 account number entry shown in Table 20

appears in RPS as shown in Figure 2 on page 33.

Figure 2: Account Number Entry

22 33 44 5511

3 4 5 6 7

1 - RPS account number entry

2 - Corresponding D5200 account number digits

3 - Digits 1 and 2

4 - Digits 3 and 4

5 - Digits 5 and 6

6 - Digits 7 and 8

7 - Digits 9 and 10

Although the D5200 allows the character

“A” to be entered into the account, do not

use this character for the account number.

A# FA Bypass Max

Default: 1

Selection:

0 to 99

Specify the maximum number of combined Controlled

points that can be faulted or bypassed when arming

this area.

Refer to the prompts

P## FA Retrnable

and

P## BA

Retrnable

in Section 4.2 Point Responses on page 84 for

returning a point to the system when the point returns

to normal or when the area is disarmed.

Users can bypass more points than the

number entered here during the disarmed

state. It is only when the user attempts to

Bypass Arm an area (or areas) that this

restriction is enforced.

A# Delay Res

Default: No

Selection:

Yes or No

Yes Point Restoral Report is not sent until

the bell time expires or user

acknowledges alarm condition.

Restoral Reports are sent when point

restores, regardless of bell time.

A# Exit Tone

Default: Yes

Selection:

Yes or No

Sounds an exit tone during exit delay at all keypads

assigned to this area.

You can turn off exit tones for individual

keypads by programming the appropriate

CC# 1 to 8 as No in CC# Exit Tone.

A# Exit Dly Time

Default: 60

Selection:

Blank (0) to 600 ( in 5 sec

increments)

Exit delay time for this area when Master Exit or

Perimeter Exit arming.

Points programmed for instant alarm

response generate alarms immediately,

even during exit delay. To avoid instant

alarms on points adjacent to the perimeter

when leaving the area, program P##

Type in the Point Index as 3 (Interior

Follower).

For SIA CP-01 Compliance

The Exit Delay Time must be between 45 sec and

255 sec.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 139 140

Comentarios a estos manuales

Sin comentarios

Bosch D7212GV2 Guía de instalación Pagina 33

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch D7212GV2