Bosch D7212GV2 Guía de instalación descargar pdf (Pagina 96)

D7212GV2 | Program Entry Guide | 4.0 RADXPNTS EN | 96

Bosch Security Systems, Inc. | 1/08 | F01U003804-04

Two relays can activate when this point

enters into alarm if the P## Rly Resp Type

for this point is programmed.

Use these codes to activate relays on the

D8129 OctoRelay (or C8137 Transmitter

Interface). You can assign the same code

to several points providing a summary zone

alarm output. When the point enters into

alarm, the relay activates. When the alarm

is acknowledged and is no longer scrolling

in the keypad display, the relay resets.

P### Point Text

Default: Refer to the program record sheet

Selection:

Up to sixteen alphanumeric

characters

Enter alphabetic characters (A to Z) in capital letters.

Enter up to sixteen characters of text to describe the

point. This point text is shown at keypads, if the point

is programmed as visible, and sent to the D6500 or

D6600 when transmitting in Modem IIIa

format (if it

is a reporting point).

Include the point number in custom point text. This

helps the user when viewing events, creating bypasses,

and so on. It can also simplify troubleshooting.

When a D1260 Keypad is installed on the

system, the point text for Points 240 to 243

can be used for Area Name Text for Areas

1 to 4, respectively. Refer to Table 29:

Table 29: Point Text for Points 240 to 243

Point Text Corresponding Area Name Text

Point 240 Area 1

Point 241 Area 2

Point 242 Area 3

Point 243 Area 4

4.4 COMMAND 7 and COMMAND 9

These entries assign point indexes, BFSK report code,

BFSK relay that activates, and the text for the

COMMAND 7 and COMMAND 9 keypad functions.

CMD7 Point Index

Default: 31

Selection: Blank (00) to 31

This entry selects one of the 31

P## Index

codes that

define how the control panel reacts when a

COMMAND 7 is initiated (refer to the

P###

BFSK/Relay

prompt on page 95).

The point index code used for COMMAND

7 must not be used for any other points on

the system.

CMD7 BFSK/Relay

Default: 1

Selection: 0 to 9

This entry selects one of the digits shown for reporting

in BFSK or for activating relays 9 to 16 for the

D7212GV2 when COMMAND 7 is initiated (refer to

the

P### BFSK/Relay

prompt on page 95).

COMMAND 7 does not activate the

Summary Fire Alarm relay.

CMD7 Point Text

Default: [COMMAND][7]

Selection:

Up to sixteen alphanumeric

characters

Enter alphabetic characters A to Z in capital letters

Enter up to sixteen characters of text to describe the

point. This point text appears at keypads (if the point is

programmed as visible) and sent to the D6500 or

D6600 when transmitting in Modem IIIa

format (if it

is a reporting point).

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 139 140

Comentarios a estos manuales

Sin comentarios

Bosch D7212GV2 Guía de instalación Pagina 96

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch D7212GV2