Bosch D7212GV2 Guía de instalación descargar pdf (Pagina 92)

D7212GV2 | Program Entry Guide | 4.0 RADXPNTS EN | 92

Bosch Security Systems, Inc. | 1/08 | F01U003804-04

P## Report Bypass at Occurrence

Default: No

Selection: Yes or No

Yes

Send a Command Bypass Report

when the point is bypassed.

Do not send a Command Bypass

Report when the point is bypassed.

Send a Command Bypass Report as soon as a user

bypasses the point from the keypad. Enable this option

for all Bypassable 24-hour points. You can also report

a bypassed point at the time the area is armed. Refer

P## Defer BP Report

on page 92.

P## Defer BP Report

Default: No

Selection: Yes or No

Yes

Send a Point Bypass Report with the

Closing Report instead of a

Command Bypass Report when a

user bypasses the point.

No Do not defer Bypass Reports.

Use this option to prevent

P## Type

(0 to F) points

that are bypassed by the user (COMMAND BYPASS)

from occurring until the area is armed. When the area

is armed, the bypassed points and any point being

bypassed during the arming sequence report as POINT

BYPASS along with the Closing Report.

When P## Defer BP Report is set to Yes

and Closing Reports are suppressed by

using Closing Windows, the deferred

Bypass Reports are not sent.

Bypass Reports for 24-hour points do not

report If P## Report Bypass at

Occurrence and P## Defer Bypass

Report are both set to No.

To report the bypass at occurrence and

when the area is armed, program P##

Report Bypass at Occurrence and P##

Defer Bypass Report as Yes. A Command

Bypass Report is sent as soon as the user

manually bypasses a point, and a

supplemental Point Bypass Report is sent

with the Closing Report.

P## Cross Point

Default: No

Selection: Yes or No

Yes This point is a Cross point.

No This point is not a Cross point.

Do not use Cross points for Fire points.

The

P## Cross Point

option is designed to reduce

false alarms. To achieve this, program two or more

points within a Cross Point Group with this prompt

enabled. The Cross point feature is available only on

points where

P## Pt Response

is set to a value that

generates an instant alarm response.

The Cross Point feature does not activate when a fault

occurs on Controlled points (Point Types 1, 2 and 3) in

the disarmed, entry delay, or exit delay states. Refer to

Section 6.9 Cross Point Parameters on page 132 for

additional programming requirements to program the

Cross Point Timer.

If an abort window delay is needed for the cross zone

alarms, all cross zone points in the group must have

P## Alarm Abort

set to Yes (refer to page 93).

The Cross Point function applies only to

Instant Alarm conditions. It does not apply

to Trouble or Supervisory conditions.

P## Fire Point

Default: No

Selection: Yes or No

Yes This point is a Fire point.

No This point is not a Fire point.

Use this option to make a 24-hour point a Fire point.

This option makes this point the highest priority event

in the control panel when an alarm occurs for both

reporting and displaying on the keypad. Refer to

Section 4.2.2 Characteristics of a Fire Point on page 84.

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 139 140

Comentarios a estos manuales

Sin comentarios

Bosch D7212GV2 Guía de instalación Pagina 92

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Bosch D7212GV2